First AWD DSM Project

[crazy_skier]

so this is a lil bit off topic but are you pulling the engine and tranny or just dropping the tranny?? if pulling the engine with it where do you bolt the engine lift on if you leave the head on. Thanks and its lookin good

[BKs50trimGST]

there are 2 spots on the engine, i dunno how to explain, one is by the bottom right corner of the valve cover, and the other one is by the top left corner of the valve cover, i can't think of the name at all, anyone else who's reading this help me out. lol, sorry

[johnson]

one is on the t.b. and one is on the exhaust mani/ power steering......

and 240 is not too much at all...... but maybe not first pull..... always gotta tune.....

[BKs50trimGST]

I was just doing a little work on the car today and pulled off the old aftermarket exhaust. It took me actually awhile because of ALL THE RUST. When all said and done, the exhaust was a Race Magnum catback exhaust, but it had to be really old becasue this wasn't stainless steel.

[BKs50trimGST]

its been a while since i've posted anything about my project but here is what i've done... i figured out that the sparking was coming from the top of the tranny, there was a crack by where a bolt should of gone... so there was about a 1/4 of an inch gap at the top, causing for the starter to grind thus making all the sparks i had. I had the tranny welded and all i have left to do is put the exhaust i got for it and put the fluids in.. then i should have my 1g awd ready to go. i might put a video of it first being turned over, i'm really excited about it. but thanks for all the support.