AN Fittings

[blageo23]

Im going to Install my external oil cooler with stainless line and AN fittings. Where is a good place to get these fittings? Also Whats a good brand? Any local place have these?
Thanks,
Mike

[Jakey]

http://www.anplumbing.com/

[npaulseth]

For local places, check hydraulic stores/shops. That's where i bought mine. $0.82 for a -4 to 3/8" 90* fitting, which is over $4 at the site listed above.

[blageo23]

I checked ANplumbing and its $160 for everything I need. Thats why Im trying to find something else.

Where is there a hydraulic store need the cities?

[Swifty1638]

I had just installed an external oil cooler on my car, but it had all the fittings i needed..stock ones (i used a different oil cooler, so it won't blow out on me, like shane's once did). I needed fittings for that oil filter housing for the oil feed though, since the frame was in the way..i got a 90 deg. bend, and a male tl male fitting. I got the fittings from mas, right off of uni.

-A. Swift

[npaulseth]

I checked ANplumbing and its $160 for everything I need. Thats why Im trying to find something else.

Where is there a hydraulic store need the cities?

Not sure.

www.yellowpages.com

I'm in Eau Claire, and just happened to stumble on this hole-in-the-wall shop that had them.

[slowbubblecar]

jegs and summitt sell AN fittings also

[npaulseth]

If you make a list of AN fittings you need, I could get them for you a lot cheaper than $4 a peice.

[tim]

If you make a list of AN fittings you need, I could get them for you a lot cheaper than $4 a peice.
I will definitely keep that in mind, that shit is spendy.

[scheides]

That racing shop on the east side of 280 on university has a ton of them.

Mas Racing Products
2288 University Ave W, St Paul, MN
(651) 644-6811