AN Fittings

[carltalon]

Ive got them at TNT I think there in blane and MAS.

[blageo23]

If you make a list of AN fittings you need, I could get them for you a lot cheaper than $4 a peice.
PM Sent.
Maybe Ill go check out MAS one Of these days too. Has anyone been to that place on uni kinda by MAS next to subway on the north side of UNI? It starts with a P or something. Its a plubming store I think and they sell Tbolt clamps. I wonder if they sell fittings.

[Swifty1638]

propulshun..um..no.

-A. Swift

[Shane@DBPerformance]

You are thinking of Pirtek.

[LingLing]

what are the specs of fittings and line we need to do AN fittings for the external oil coolers?

[blageo23]

Oil cooler-
7/8X14 to -8AN
-8AN 120 degree fitting
Filter housing
M16X1.5 to -8AN
-8AN 90 degree fitting

[LingLing]

Awesome. Thanks much.

[Tachyon]

That racing shop on the east side of 280 on university has a ton of them.

Mas Racing Products
2288 University Ave W, St Paul, MN
(651) 644-6811


Sorry to bump this from the grave, but I need to get several An fittings this week and this place appears to have it's number disconnected. Can anybody confirm that they are still around?

If not, where should I go in the TC?

Thanks!

[Matt D.]

Full Blown had a decent selection at one time, give them a call.
www.fullblownmotors.com

There was also a shop in the northern suburbs at one point but I can't for the life of me remember the name. When I bought fittings before I just ordered them from Jegs or Summit.

[slo6oh]

Sorry to bump this from the grave, but I need to get several An fittings this week and this place appears to have it's number disconnected. Can anybody confirm that they are still around?

If not, where should I go in the TC?

Thanks!

MAS is closed for good, aggressive hydro. might have what your looking for, they are located in blaine.