Quote:
Originally Posted by goodhart
Did you make new piping too? I though your old stuff was polished?
|
Just the intake was polished.
Its been a while since my last update. I sent my turbo out to be rebuilt, since it was pushing a little oil in the exhaust housing. I finally got it back and installed it. I upsized the turbo oil drain to AN10 from AN8 too.
I also sent out my injectors to FIC for testing, cleaning, and balancing. The results were interesting. The 2150s were within 2% match of one another, however the flow rate was down to a 1950 average! My secondary 900s were spot on. FIC was able to get the 2150 back in spec.
I took the oil pan off the car to update the turbo drain fitting and to inspect the lower end. Everything looks good. I also welded in another clamshell IC piping clamp. It is ready for the season! I dont know if Im going to get to my K-member done this year unless I get started very soon or purchase one.
__________________
Slowest: 2017 Corvette Z06 - Z07 Trim
Fast: EvoIX SE Blouch 2.0xtr turbo E85
Faster: Evo IX MR PTE6266 E85 823WHP 9.90@147
Fastest: 92 Talon AWD 8.14 @ 171 MPH
www.maperformance.com