Well after I fabbed up the rest of my exhaust. I was able to hear an exhaust leak I had. It was between the hot side on the turbo and the o2 housing. I decided to take a straight edge to both of them and apparently both of them are warped. So now what the hell do I do? Double gasket?
Double gasket + high temp rtv? Take them to a belt sander?
It's a quarter inch thick so it should be fine. Now I just gotta find someone with a belt sander.. Haha. What's even more frustrating is non of the holes line up very well. I had to drill them out a lot just to get it to bolt down.
Belt sander and ultra copper, all a machine shop is going to do is toss it on a belt sander and charge you $40 for something you could do in 5 minutes.
__________________
Quote:
Originally Posted by scheides
I swing from the nuts of cold hard data. Anything less is a guess.