WTB 1g HEAD

[TalonTSI95]

looking to purchase a 1g head, looking for the cams to be good dont care about the rest really, as i have all of them.

[TkrPerformance]

I have a set of evo III cams I just took out of the car the other day and a bare head

[MATCHBX]

I have a complete head with intake. Cams are in good shape as well and it has 3rd gen HVLA's to eliminate lifter tick.

[TalonTSI95]

what do you guys want for them? basically right now i am trying to keep a budget but if i go a little over and get a better setup i'm willing to do so.

[TkrPerformance]

50 for the bare head
100 for the evo cams (bigger than 1g cams)

[rst95eclipse]

$120 for 1g with everything. It has a few bent valves. I have extra stock valves. You'll just need to replace the valves. It would be a good idea to have it decked and the guides replaced.

[MATCHBX]

I'd go $175 on mine. It has everything in it and ready to go. One exhaust stud broke off inside of it, but a machine shop could get it out cheap. Otherwise it was decked, 3 angle valve job done, valve guides knurled, new valve stem seals, cleaned and it was checked for cracks. Has about 5000 or so miles on it since this was done. I pulled it off of my old engine before I threw a complete 6-bolt in the car. It hasn't been used since. It is a 6-bolt head off of a 91 GSX. It was on a 93 7-bolt block before the balance shaft bearing went out in the engine. Caused no damage to the head. Pics can be found in this thread.

http://www.dsmstyle.com/forums/showthread.php?t=15091

[joem]

50.00 good head bad valves.
Joe

[Swifty1638]

I have stock 92 cams. Make an offer.

-A. Swift

[joem]

Plus my also has cams m/t 92.
Joe

[x1genx]

I have a complete head with cams that is perfect.
No bent valves. Ran perfectly on good compression too.
Head is pulled and sitting in my room

erik