|
Re: FS: Shaved & Polished Valve Cover
Quote:
Originally Posted by sleepydsm
Hey, are you milling the tops of the valve covers? When you say its in teach mode, are you then using those... wtf controller is that, not Fanuc but with an M or N, Masic? Uh... I dont remember, I just remember that "teach" function.
Are you just running a shell mill or just an end mill over the letters so its near flush?
|
__________________
If I spent the same amount of $ on my car as I do on booze I'd have a 9 sec car by now!
|