MitsuStyle - View Single Post

Swifty1638 · 03-11-2005

IF you have the time to sit around, you can go to tires plus, or any place like that. They have a lathe that will cut your rotors for ya. Also, you can turn, and measure thickness on drum rotors. My old job had a machine for that too( usually, they are both as one big machine-disks, and drums) the micrometer was a little different, and it measures the inside if the drum. Take the measurement at different points, and you can usually tell if they are good or not.

-A. Swift

03-11-2005	#16
Swifty1638 Unsure resident asshole Join Date: Mar 2005 Location: MN Drives: '92 Eagle TalonTSI w/many mods Posts: 3,696	Re: Dumb question inside...only read if u arent gonna flame lol IF you have the time to sit around, you can go to tires plus, or any place like that. They have a lathe that will cut your rotors for ya. Also, you can turn, and measure thickness on drum rotors. My old job had a machine for that too( usually, they are both as one big machine-disks, and drums) the micrometer was a little different, and it measures the inside if the drum. Take the measurement at different points, and you can usually tell if they are good or not. -A. Swift Last edited by Swifty1638; 03-11-2005 at 06:59 PM..