So the AEM will be a few weeks yet since he has to make a special harness for me. In the mean time, I've picked up some stuff. Got some of those Aero hood pins for the new hood. Also got all my sensors I'll need. AEM SS 5 bar MAP sensor, AEM SS 100psi fuel pressure, GM Flex Fuel, & a MAC 3-port boost solenoid. Good news was I had enough points on my credit card that I got all those sensors, plus a new Ryobi ONE cordless setup for free!
I also have some new ABS sensors on the way that I'll need for setting up traction control.
I also got my new Tilton Clutch Master Cylinder half installed. Hopefully I can get it further installed over the next week or so and figure out if that fixed my tranny issue. If not, then yaay that pig gets to come out. Crossing my fingers that doesn't have to happen.