View Single Post
Old 09-15-2022   #15
niterydr
back in the saddle again
 
niterydr's Avatar
 
24 Hours Rally Champion! 3D Pacman white house edition Champion! 3D Racing - Track 2 Champion! ATV Winter Challenge Champion! Bloody Pingu Champion! WRX Racing 2 Champion!
Tournaments Won: 5

Join Date: Oct 2003
Location: Elkhart Texas
Drives: 2015 Ram Quad Cab Hemi, 1999 FRC Corvette, 93 Stealth Turbo
Posts: 6,411
Send a message via AIM to niterydr
Re: I finally have another Mitsubishi...yes this is my old stealth

Quote:
Originally Posted by Speedfreak View Post
Whats the axle and driveshaft solution for fitting 4g63 stuff in one of these?
A few different options. Bolt on mounts exist. Depending if you are going automatic or manual you use one of the two rear ends available in the vr4 version.
Axles work with mitsubishi components. Generally a FWD pass axle and some cup swapping to make the driver side work (assuming you are starting with a TT chassis, another route is to go with a Non turbo chassis and its a bit easier as hubs clear, but then you're fwd).
AWD - move the yoke to match the dsm driveshaft. Or talk to DSS and have a shaft made to replace the front 2.

Of course I haven't finished all this, just research. Will post my results here as the drivetrain goes in. Confident it'll work out.
__________________
My street car runs low 11's and my race car's personal best is a mid 11....
niterydr is offline   Reply With Quote