MitsuStyle - View Single Post

bramagedained · 06-13-2016

I'm really shit at keeping with the updates it seems. I'll have pictures up later tonight. I had a driveshaft made on Friday. Was ~$280 with tax from Proven Force. That was the last missing piece to take it for a drive.

It's getting close.

My to-do list:

Check all new fitting connections. Fuel/trans/brakes/coolant.

Set preload on front wheel bearings-Need to buy cotter pins.

Bleed Brakes.

Adjust Booster->MC pushrod.

Re-Install exhaust.

Wrap up wiring. Dome light and +12v to cigarette lighter for cell charger.

Sand the seam sealer on rear fender arches and paint bare metal.

Modify carb. -Remove and drill two holes in butterflies for idle.

Set timing. I need to buy a timing tape for the damper.

Mount battery box.

Make access hatch for fuel cell. I have sheetmetal and piano hinge.

Alignment.

Proceed to coat quarter panels with rubber.

06-13-2016	#114
bramagedained Join Date: May 2010 Location: KY/MN/Afghanistan Drives: EVO IX SSL Posts: 413	Re: My "new" car/project. I'm really shit at keeping with the updates it seems. I'll have pictures up later tonight. I had a driveshaft made on Friday. Was ~$280 with tax from Proven Force. That was the last missing piece to take it for a drive. It's getting close. My to-do list: Check all new fitting connections. Fuel/trans/brakes/coolant. Set preload on front wheel bearings-Need to buy cotter pins. Bleed Brakes. Adjust Booster->MC pushrod. Re-Install exhaust. Wrap up wiring. Dome light and +12v to cigarette lighter for cell charger. Sand the seam sealer on rear fender arches and paint bare metal. Modify carb. -Remove and drill two holes in butterflies for idle. Set timing. I need to buy a timing tape for the damper. Mount battery box. Make access hatch for fuel cell. I have sheetmetal and piano hinge. Alignment. Proceed to coat quarter panels with rubber.