View Single Post
Old 04-13-2011   #47
Mark Leasure
 
Mark Leasure's Avatar
 

Join Date: Aug 2006
Location: eagan
Posts: 898
Re: Mark's 1G Winter Projects

Quote:
Originally Posted by URV8SUX View Post
Awesome looking forward to seeing what it picks up at the track!
I’m going to dyno it to after I get my Magnus V3 Cast intake on the car. I did check the IDC @ 35 PSI, on a set of 2150’s it is 83% @ 9krpm, with an AFR of 11.6. I’m using a base fuel pressure of 44.5psi. I don’t have a comparison to that from the old setup. I would need to turn the boost up to the mid 40 psi range to even start to compare.

In the power department I changed a lot of things this year:
Map stage 5 head (The head that was on the car was a factory cast head!), bumped compression by a point, billet 76mm compressor wheel on the 42R, 3.5 aluminized steel to 4” aluminum exhaust, and to wrap it up I’m waiting on the new cast Magnus intake manifold.

I also figure that I removed 125 lbs from the car, even with adding carpet and door panels.

This year should be good, hoping to get deeper in the 9’s, a trap speed of 160+ would be nice too.
Mark Leasure is offline   Reply With Quote