Thread: UBER SS
View Single Post
Old 01-19-2016   #60
1ViciousGSX
Admin
 
1ViciousGSX's Avatar
 

Join Date: Oct 2003
Location: Sportsman's Paradise, LA.
Posts: 5,382
Re: UBER SS

A few more goodies going in.

Coan Max Perf 9-inch converter COA-20440-1
4800 flash stall with less than 6% slip on high end.
CSR832 Trans/Bellhousing shield.



In looking at the numbers I figured out the engine is just blowing through the converter I have now. By doing the math (32 inch tire/4.10 gear/6700rpm/6% converter slip) I should be rolling through the traps closer to 145mph instead of 127-128mph. I was hitting 6700rpm a couple of hundred feet before the traps, so basically the engine was topped out and the car was still picking up speed. Not a good scenario. Also explains why the e.t. and mph are not as strong as they should have been.

I decided to go with the CSR shield because it snug fits against the tranny housing to clear the floor board. Figured since I didn't have a tranny shield, now would be a good time to install one.

Looking at different transmission cooler options now.
__________________

"You don't have a clue. You couldn't get a clue during the clue mating season in a field full of horny clues if you smeared your body with clue musk and did the clue mating dance."

When she get's bitchy, SPANK THAT ASS!
(#Y#)

Last edited by 1ViciousGSX; 01-19-2016 at 04:08 PM..
1ViciousGSX is offline   Reply With Quote