MitsuStyle - View Single Post - Clutch Low Engagement(yea, I know it's a DSM)

joesushi · 02-03-2009

Had this problem all the time and i always got it fixed. IF: There are no bubbles in the system. The pivot ball has been shimmed. the flywheel is stepped properly. And everything you can think of has been done then i would seriously recommend extending the threaded master cylinder rod. On all three of my 1g's, this fixed my problem. Cut about 1/4-3/8'' of the threaded end off and have about a 1/2'' of some other bolt with the same thread welded on. Then reinstall and you should have instant engagement at the top. You are welcome to see it working on my bro's talon anytime.

02-03-2009	#8
joesushi Smells Like Fish Join Date: Nov 2004 Location: Maple Grove Drives: 96GSX Posts: 215	Re: Clutch Low Engagement(yea, I know it's a DSM) Had this problem all the time and i always got it fixed. IF: There are no bubbles in the system. The pivot ball has been shimmed. the flywheel is stepped properly. And everything you can think of has been done then i would seriously recommend extending the threaded master cylinder rod. On all three of my 1g's, this fixed my problem. Cut about 1/4-3/8'' of the threaded end off and have about a 1/2'' of some other bolt with the same thread welded on. Then reinstall and you should have instant engagement at the top. You are welcome to see it working on my bro's talon anytime. __________________ out-running the velocichoppa! in my dsm. Last edited by joesushi; 02-03-2009 at 11:52 PM..