thanks for the feedback guys!
At this point the cage is close to being done. I just need to get the front of the funny car cage bent and welded in. I need to buy a new 1.5" bending die for this, so i need to wait a week or two until the die shows up. I also need to figure out a custom window net setup, mount the seat, and fabricate mounts for the steering column. My goal is to have it certified this month!
My chassis fabrication confidence has grown and this has been an awesome project so far!
It's a shame I'm going to paint the cage, not all of the welds are this clean, but the majority are good like this.
__________________
Slowest: 2017 Corvette Z06 - Z07 Trim
Fast: EvoIX SE Blouch 2.0xtr turbo E85
Faster: Evo IX MR PTE6266 E85 823WHP 9.90@147
Fastest: 92 Talon AWD 8.14 @ 171 MPH
www.maperformance.com