Quote:
|
Originally Posted by Enes
when i put it all back together and line it up to TDC on the cyl 1
and line up the outside marks of the cam gears the inside 2 marks are below the straight edge. by about 1 mm each.
|
Enes- Mine is the same and it's fine. If you take a straight edge and put it accross the cams gears, the 2 inside marks are fine but i believe one of the outside marks i think was a bit off. I think it was the one towards the car. I think it's got someting to do with the inside marks [ one mark is on an actual tooth and the other mark would be the female i guess you could say]