http://cgi.ebay.com/ebaymotors/ws/e...ssPageName=WDVW
http://cgi.ebay.com/ebaymotors/ws/e...bayphotohosting
Do you mean 650 cfm? Here are the links from before. I am not so sure I believe it will go in without taking out the support. It looks like it is 2.8" thick so it might. I have only installed 3.5 inch ones. It looks like you will most likely be running long route piping the way the end tanks are or at least not have to cut the frame rail. On slowbubblecar's 2g, his core is 28" long and his endtanks pointed straight towards the engine so he had to cut a lot. It should be a good setup when it is done though.