[Raptor]

Excellent, I decided I better pull the head off and check the pistons and ring gaps etc, considering the bottom end of this thing. Glad I did, First thing I notice is all the ARP's backing out, after that, pull the head off and see all the pistons sitting 180 out, in other words backwards. Some people may not think that matters a lot, but I assure you it does. The Piston pins are offset to one side, it effects quite a bit. Most obvious would be piston slap and wear. Also incorrect TDC to the valve timing events etc. Then there is a distinct lack of any lubrication on the cylinder wall, they are completely dry. The ring gaps are a little loose on the first ring, but tollerable, the second ring is exactly the same which is not tollerable. Along with a few other stupid things like the presence of an un-identified grainy substance in the cylinders (possibly from a cylinder hone) and of course the ring gaps being all lined up nicely. The importance of that has been in debated for years, some claim it doesn't matter some say it does, I can see arguments for both sides and likely it doesn't matter since the rings are completely free to rotate in whatever way they choose, I of course still take the extra time to put them in a nice staggered way. If it helps great, it can't hurt. Either way, this person should not have assembled an engine. Not a cheap one, expensive one or otherwise.