MitsuStyle - View Single Post

Onefast99gsx · 04-30-2005

Yes, i stuck the pin and i felt it go thru. Well, i stuck it the first(outter) hole, then it went into the middle(the actual hydraulic pin) just fine no resistance. I was having difficult catching the back hole mainly just because it was tough to get at. I can try lowering the engine and getting a better angle at it. So if i can catch all 3 hole with little to no resistance, i'm good ya think?

Thanks Craig...

04-30-2005	#8
Onefast99gsx Join Date: Sep 2004 Location: Wisconsin Posts: 1,411	Re: Timing Belt installation HELP needed Yes, i stuck the pin and i felt it go thru. Well, i stuck it the first(outter) hole, then it went into the middle(the actual hydraulic pin) just fine no resistance. I was having difficult catching the back hole mainly just because it was tough to get at. I can try lowering the engine and getting a better angle at it. So if i can catch all 3 hole with little to no resistance, i'm good ya think? Thanks Craig...