|
Re: resurfacing...
Quote:
|
Originally Posted by 1slowdsm
My cousin was also telling me to just sand the flywheel down a little and it should be fine and I was like..."Arumm...are you sure?" I dont want to take that risk and have to take out the clutch all over again within a couple of months....that'll just suck!
Nvm, I found out where Red Rooster is located. I'll give them a call tomorrow and see if they're better of Bumper-to-Bumper is better.
Still wanna know what Unreal meant up there about 5 replies ago if anyone knows what he meant.  |
I would not sand the flywheel if you care about the clutch, I sanded the flywheel on the Talon AWD, but I put in a used clutch disk from my laser FWD.
__________________
Take her to the limit!
Last edited by unreal808; 03-29-2005 at 10:53 PM..
|