MitsuStyle - View Single Post

**1ViciousGSX** · 01-08-2005

1. 6 bolt pistons should fit 6 bolt rods without any problems. There is only an issue when trying to run 2g pistons on 1g rods.

2. I think both the rod and pistons are good for about the same power levels. If one had to be stronger then the other, the piston would probably support more power than the rod would.

3. Forged rods only please.

4. Mains studs are not the norm for the 6 bolt engine. You can run them, but the block/mains have to be recut/machined for it to work correctly.

01-08-2005	#2
1ViciousGSX Admin Join Date: Oct 2003 Location: Sportsman's Paradise, LA. Posts: 5,382	Re: A few 6 bolt questions! 1. 6 bolt pistons should fit 6 bolt rods without any problems. There is only an issue when trying to run 2g pistons on 1g rods. 2. I think both the rod and pistons are good for about the same power levels. If one had to be stronger then the other, the piston would probably support more power than the rod would. 3. Forged rods only please. 4. Mains studs are not the norm for the 6 bolt engine. You can run them, but the block/mains have to be recut/machined for it to work correctly. __________________ My new band: Fall of August Click Me --> "V" <-- Click Me "You don't have a clue. You couldn't get a clue during the clue mating season in a field full of horny clues if you smeared your body with clue musk and did the clue mating dance." When she get's bitchy, SPANK THAT ASS! (#Y#)