Quote:
|
Originally Posted by SlowWhite
It is possible you leave the motor and drop the tranny.
And I hope I just read your post wrong.. And that the Bell housing is still attached the tranny not the motor correct?
Anyways What are you trying to do? Pull the motor or Drop the Tranny?
I'm with Rockford on this one, Just bolt the Tranny back to the motor and pull them out together.
I just pulled mine last night. and ya don't forget to pull the radiator out. I have to probably get a new one. Or hope to god there is enough left on the upper Radiator hose part to attach the hose to it... (I don't know how I didn't remember to pull that thing I guess I was just focused on otherthings that were going on) Oh well hopefully in a few months a fluidyne will be in the works.
-Also I don't see how you could possbily pull the motor while leaving the tranny in place? The Shaft that goes through the Clutch would prevent you from being able to pull up with it... maybe if you were able to drop the motor throught the bottom you'd be able to. But I'm sure if this is just a Jack Stand situation the height Clearnace won't be enough.
-brian
|
We are trying to pull the block and leave the tranny. You are correct that the bell housing is disconnected from the block not from the tranny. The radiator is out already.