View Single Post
Old 08-14-2004   #2
acidrumz
 

Join Date: Nov 2003
Location: stp,mn/ca
Posts: 90
Send a message via AIM to acidrumz
bore the block, provide the new pistons for the machinist for measurements.

resurface the block and head. milling/deck is required if yours is in bad condition.

you do need a special tool to get to the valves, you should have the machinist replace your valves and valve stem seals. also if you want, he can do the 3 angle valve job so you can have a better seal. you might also have to replace your guides too.

good luck.

later.
acidrumz is offline   Reply With Quote