MitsuStyle - View Single Post

**Halon** · 02-06-2017

So here is my mostly finished design. Just shot it off to Rosey to see if he can print it. If not, I'll have to start looking elsewhere. But basically radio up top. Then my single 52mm CAN-Bus gauge in the center (with a slight recess so it sits a little more flush looking). Then two AEM 12-position rotary switches on either side of it (again with a small recess for the circle plate that comes with them). One switch will be for adjustable boost control, and the other for adjustable traction control.

02-06-2017	#10
Halon Pewp Champion Join Date: Nov 2003 Location: Blaine Drives: Teh Bean Posts: 12,309	Re: Playing With SOLIDWORKS So here is my mostly finished design. Just shot it off to Rosey to see if he can print it. If not, I'll have to start looking elsewhere. But basically radio up top. Then my single 52mm CAN-Bus gauge in the center (with a slight recess so it sits a little more flush looking). Then two AEM 12-position rotary switches on either side of it (again with a small recess for the circle plate that comes with them). One switch will be for adjustable boost control, and the other for adjustable traction control. Attached Thumbnails __________________ B-Man - FlexFuel Mafia 1991 TSi AWD E85 - BEP S362, DSMLink V2, Built 2.0L Idle Vid 628hp Graph 541hp Vid 10.93@137 Vid 1992 SC300 E85 - BW 84-75, Vlad Infinity, NA-T, 6spd Idle Vid 709hp Graph 709hp Vid 11.1@131 Vid 2006 Bayliner 195 - Carbed 5.0 Top Speed Test