MitsuStyle - View Single Post

niterydr · 06-03-2015

Gl on the rebuild. Ensure you check the rod on cylinder #3 as well to make sure length is correct and the bearing isn't damaged. I would probably just replace bearings in the lower end at a minimum but I can't bring myself to do anything but a full rebuild on anything.

Oh and straight definitions are the same. I forget they put a slalom in the rear one.

06-03-2015	#267
niterydr back in the saddle again 24 Hours Rally Champion! 3D Pacman white house edition Champion! 3D Racing - Track 2 Champion! ATV Winter Challenge Champion! Bloody Pingu Champion! WRX Racing 2 Champion! Tournaments Won: 5 Join Date: Oct 2003 Location: Elkhart Texas Drives: 2015 Ram Quad Cab Hemi, 1999 FRC Corvette, 93 Stealth Turbo Posts: 6,411	Re: Project Black ValentNine AKA DSM9.0 Gl on the rebuild. Ensure you check the rod on cylinder #3 as well to make sure length is correct and the bearing isn't damaged. I would probably just replace bearings in the lower end at a minimum but I can't bring myself to do anything but a full rebuild on anything. Oh and straight definitions are the same. I forget they put a slalom in the rear one. __________________ My street car runs low 11's and my race car's personal best is a mid 11....