MitsuStyle - View Single Post

**asshanson** · 01-21-2014

Not using Dzus for a wing, that would scare me.
There are 3 studs coming out the bottom of each mount, each one is 6mm diameter with a 10mm nut. The center studs also connect to a brace inside the trunk. So I guess to remove it I just need a 10mm wrench for each of the 6 nuts and I can leave the trunk brace in place all the time.

The clam is drilled and wing in place, just need to get the trunk brace installed. The hatch has about 1/2" clearance when opening, and the wing is mounted nearly at the back of the car. Close fit.

01-21-2014	#259
asshanson immune from paybans Join Date: Oct 2005 Location: West Des Moines Drives: poorly Posts: 4,358	Re: 2007 Lotus Exige S Not using Dzus for a wing, that would scare me. There are 3 studs coming out the bottom of each mount, each one is 6mm diameter with a 10mm nut. The center studs also connect to a brace inside the trunk. So I guess to remove it I just need a 10mm wrench for each of the 6 nuts and I can leave the trunk brace in place all the time. The clam is drilled and wing in place, just need to get the trunk brace installed. The hatch has about 1/2" clearance when opening, and the wing is mounted nearly at the back of the car. Close fit.