I worked on the car today The task was to finish this bad boy up by replacing the last remaining factory differential bushing, thanks @murlo26 for all the help!
This last driver side bushing became quite the task to remove. There's not a ton of room to use a full ball joint press like the other 2 diff bushings. I ended up rigging up a homemade press out of a 7/16 threaded rod and some nuts and washers. The impact wrench was key to start pressing the bushings out. Then I used an impact hammer to finish the bushing removal.
Here's the differential dropped with the new Pedder's bushings installed:
At this point, all suspension and handling parts have been installed onto the car. The only thing I am waiting on at this point is an alignment. The car is getting very close to streetable again, getting stoked to take this out and test!