Quote:
Originally Posted by golden763
The other thing I never thought of did u take one of the upper rod bearings out? There usually the ones that take the worst beating the upper rod bearings and lower mains
|
I have not. I can check the next time I'm over there
Quote:
Originally Posted by simulatedwood
From the pictures you posted, you are still on the first layer, for most of the bearing surface on all the bearings in the picture. It safe at this point to just reuse all the bearings.
|
I hope so. So far quite a few people have said they are useable. So I'm either going to replace the rods and use the mains or just reuse the rods and mains for this summer then pull the engine and replace all of them next winter.