MitsuStyle - View Single Post

gvr4 · 01-05-2013

I hadn't heard that part about wiping out cylinder walls either... Ahh well I'm only at .02" over. I'll go wiseco if this build doesn't last...

I already re-checked my clearances and I'm sure I'm good to go. Otherwise, I'd just stick some 40 grit adhesive backed sandpaper on the valve, and grab the stem with a cordless drill. Cutting valve reliefs isn't that hard.

01-05-2013	#26
gvr4 New Member Join Date: Sep 2012 Location: North Branch Drives: I walk. Too many broke vehicles Posts: 40	Re: Piston to valve Clearance? I hadn't heard that part about wiping out cylinder walls either... Ahh well I'm only at .02" over. I'll go wiseco if this build doesn't last... I already re-checked my clearances and I'm sure I'm good to go. Otherwise, I'd just stick some 40 grit adhesive backed sandpaper on the valve, and grab the stem with a cordless drill. Cutting valve reliefs isn't that hard. Last edited by gvr4; 01-05-2013 at 01:21 PM..