I haven't really worked on the car since my last post. I've worked on some of the dash/interior parts however. One part would be the center vent gauge holder/cluster. I cut out the holes for the buttons I plan to use.
I also just found a close size hole saw (51mm) to fit my 52mm gauges. It will at least get me on the right path of getting the gauges put where they belong.
I'm not sure if I am going to keep the stagger/angle I have between each of the gauges; like I have draw here.
Here's a picture from September of the dash and how it should be setup when I am done. Minus the gauges obviously.
On another note, I have started cleaning up my old laptop to start refreshing it for its future job as a tuning laptop. I know next to nothing about computers or operating systems so I will probably have to look around on what I want to do with this. Especially as far as upgrading it goes. None the less, here she is in her unfound glory.
Since winter is starting, and the Colt is DAMN NEAR done (thank God), I am going to start from the ground up with this thing. Suspension and possibly braking is on my list of things to do. Stay tuned for that. Thanks for looking!