MitsuStyle - View Single Post - LC-1 and narrowband sim

dsmghost · 06-24-2012

I have a 94 talon tsi with V3 and I installed my LC-1 just like this,

Narrowband simulation install (DB gauge, Logging, ECMlink v3 setup)
[LC-1 sensor placed in front o2 spot]
Red wire – 12v accessory power source
Blue wire – chassis ground
White wire - ECU sensor ground (pin 24)
Brown – ECU pin 15
Yellow – DB gauge’s white wire
Black – Calibration push button to monitoring LED to ground

I enabled narrowband sim using the front o2 spot and chose LC-1 wideband, did the free air calibration, and reprogrammed analog out 1 values to match analog out 2 values. My gauge reads what seems to be correct, but on v3 its logging a constant 7.5:1, How do I log what my gauge reads?

06-24-2012	#1
dsmghost Join Date: Nov 2011 Location: South Minneapolis Drives: 1gb Talon TSi AWD Posts: 525	LC-1 and narrowband sim I have a 94 talon tsi with V3 and I installed my LC-1 just like this, Narrowband simulation install (DB gauge, Logging, ECMlink v3 setup) [LC-1 sensor placed in front o2 spot] Red wire – 12v accessory power source Blue wire – chassis ground White wire - ECU sensor ground (pin 24) Brown – ECU pin 15 Yellow – DB gauge’s white wire Black – Calibration push button to monitoring LED to ground I enabled narrowband sim using the front o2 spot and chose LC-1 wideband, did the free air calibration, and reprogrammed analog out 1 values to match analog out 2 values. My gauge reads what seems to be correct, but on v3 its logging a constant 7.5:1, How do I log what my gauge reads?