[blackawdtsi]

Do this.

Originally Posted by spin'n 4

Here is a quick write up on how I did the pump install.
I used a -6 bulkhead found at summit racing.

http://www.summitracing.com/parts/ABT-TF602/

I used a cut off wheel to cut the fuel feed line off the top if the sending unit. Then used a unibit, drilling down through the feed hole untill the the fuel pumd receiver fell off. I then switched to a 14mm drill bit to finish the opening so that the bulkhead would slide through.




Next I cut part of the nipple off the top of the pump so that it wouldn't be to deep for the tank and connected the pump to the bulkhead with a 5/16 hose that came with the pump.




I trimmed down the rubber isolator for the bottom of the pump and secured it with the retainer bracket.