MitsuStyle - View Single Post - Anyone want to make a newbie make some good power?

bramagedained · 05-21-2012

The FWIW, my car was fine with the factory head studs at 514whp/454wtq. Though, I only ran that setup for 1 season so YMMV.

I ran the stock valvesprings with Cosworth M2 cams since I bought the car in 2009, with the limiter set to 8k which it saw more than a few times without issue too. I found out from the previous owner a few months ago that the cams had been in the car since 2007.

For labor and tuning, I have only good things to say about Shane and DB as a whole.

05-21-2012	#28
bramagedained Join Date: May 2010 Location: KY/MN/Afghanistan Drives: EVO IX SSL Posts: 413	Re: Anyone want to make a newbie make some good power? The FWIW, my car was fine with the factory head studs at 514whp/454wtq. Though, I only ran that setup for 1 season so YMMV. I ran the stock valvesprings with Cosworth M2 cams since I bought the car in 2009, with the limiter set to 8k which it saw more than a few times without issue too. I found out from the previous owner a few months ago that the cams had been in the car since 2007. For labor and tuning, I have only good things to say about Shane and DB as a whole.