So here it goes. I've been buying cars parts left and right and now seem to have found a shell I could be happy with building knowing it can be done right.
People that I want to thank so far since I've got back in. Jim(talonfiero). Thanks for getting me back and teaching me how to swap trans. Brad (celicabrad) knowledge and parts. Aaron(turbotalon1G) giving me a plan of how to build a car and just keep 1. Tom(blacktalontsi) for giving me a great deal on a car that is absolutely rust free and tons of dsm parts to boot.
And all of you on here that helped out and been over either buying parts or selling me some.
Enough of that on to the good stuff
I recently picked up a shell that came from Texas. Originally jungy had it did a few things like wire tuck, brakes, suspension ect. Then Tom bought it and now I own it. Car was purchased as a shell but had a ton of parts included
Ok so parts I already have
Exterior
Koni yellows w/eibach coil/springs
16" Rota slips
drilled rotors
2GB talon front bumper
2GB talon rear bumper
95 talon twist sides
ABS delete w/SS lines
3" v band down pipe
Custom front exit exhaust
Carbon fiber hood
Interior
DSM link v3
Aem wideband
Phantom gauges
Boost
Oil press
Water temp
Volt
Black interior
Door skins
Dash
Center council
Rear speaker covers
Door handles
Tenzo R seats
Engine
2.4 6 bolt shortblock
CP 87.5 9:1 pistons 22 wrist pins
Manley h beams w/22mm wrist (new style)
Kiggley main girdle
ARP main studs
L19 headstuds
Cometic MLS 87.5 headgasket
Turned down BS
1G head slight port
FP beehives
GCS 3 cams
OBX ramhorn t3 Manifold
Motor is at gosh will be gone through machined and assembled Pistons are still 3 weeks out
Fuel
Aeromotive fpr
Walbro 450 pump (new e85 design)
Kenne belle boost a pump
FIC 2150cc injectors
Stock rail with an fittings
680 small battery
FP non recirc with k&n filter
Things I still need to order
SD setup
Turbo? Still undecided but 6262 or bigger t3 with 3" v band
Magnus v5 intake
Send out my evo 1 trans to Tim Zimmer for some upgrades
southbend carbon Kevlar clutch holds 600 tq
Tial bov
Tires for slips
Carbon hood/hatch
ETS core
Custom 3" cooler piping
Thanks again Jugny and Tom for keeping a clean car clean and hope to have it up by proving grounds
Pics I hope privious owners dont mind
Ill add more pics and phots as i get the motor and parts in just waiting for the brown truck to show up so I can keep moving forward.