[Tachyon]

Got a decent amount done in the last couple of days:

• Finished replacing 100% of the bushings in the rear subframe, including mustache bushings
• Added active toe eliminator from s1ngletracker (perfect fit, btw)
• Added a RM rear sway bar
• Added poly bushings to the front sway bar (this was a bitch)
• Installed Ingalls adjustable upper control arms
• Installed new clutch (went with 6 puck unsprung over 4 puck this time)
• Replaced the power steering rack with Kevin/Mondale's low mile unit -added new end links
• Re-installed engine and transmission
• Fabbed new intercooler pipes for short route to clear my whale penis intake pipe
• Fixed my propeller shaft (it met a train track in Minneapolis last fall)

All that's left is to add fluids and toss the suspension back on and I am read to rock the casbah.

I'd like to note, I am bit apprehensive driving this new setup as I am used to employing fairly strong amounts of trail braking to initiate rotation on corner entry. I suspect I am going to over rotate a few times getting use to the new setup