|
I have the wiring all taped up but i will be pulling hte fans and moving them closer up a bit to the radiator, at that time i will give you the diagram.. and because the fans before were ran independently i would suggest doing it the same again. and also did you swap the blades from pull to push? make sur eyou put some lock tite on the nut otherwise it might come loose from the vibration..
Eric helped with my wiring, actually he ended up doing most of it. But we ended up using two wires for power for each fan and one ground.. reason is because before the fans used to be dual speed and when ecu kicks it into higher spead one of the wires will stop working.. and if we hooked it up to low then it wouldn't run.. if we hooked it up to high it would never turn on until the ecu tells it to go into higher speed..
-E
__________________
|