MitsuStyle - View Single Post

TkrPerformance · 11-05-2011

been working on it the last 2 days. Pulled the engine out of the corner. Pulled the valve cover to swap in the FP2 cams and one of the cam cap bolts pulled all the threads with it

was not happy since it was the cnc ported head that is now junk and is all taken apart for scrap now. Luck I had one good 2g head that will be going on the engine now since that is what I had laying around.

so today I got the short block,tranny,t.c,and axles,and down pipe in the car

also took the turbo apart to cut out the flapper since I will be running a tial 38 gate

cut the flapper arm off flush and put it back in and welded it back on

all back together out

11-05-2011	#38
TkrPerformance Join Date: Oct 2003 Location: edward lake Drives: toaster Posts: 6,431	Re: after 10 years its coming back to life been working on it the last 2 days. Pulled the engine out of the corner. Pulled the valve cover to swap in the FP2 cams and one of the cam cap bolts pulled all the threads with it was not happy since it was the cnc ported head that is now junk and is all taken apart for scrap now. Luck I had one good 2g head that will be going on the engine now since that is what I had laying around. so today I got the short block,tranny,t.c,and axles,and down pipe in the car also took the turbo apart to cut out the flapper since I will be running a tial 38 gate cut the flapper arm off flush and put it back in and welded it back on all back together out Last edited by TkrPerformance; 11-05-2011 at 08:48 PM..