Hrm, lookee what landed on my work bench this evening
These pics do not do this manifold justice--it is smooth and SO SEXY on the inside!
This is MAP's Rev3 port job. They cut open the plenum for maximum awesomeness of the port job, then weld it back together. Only thing I'm a little disappointed about, I was hoping to strap on a 64mm throttle body to this some day and ummmm yea. Hopefully my caliper is off (but I doubt it), it's just a cheapy.
The inlet is opened up to only about 62mm
I spoke with MAP and they assured me it would fit with a 64 so idk...my tools are not that accurate but whatever....I'll deal with that down the road.
Here's the stock TB, only about 60mm:
Quick rip around teh block and the car is leaning out almost a full point--that's a good sign I think
