MitsuStyle - View Single Post

GsXtUrBo98 · 06-11-2011

I got the new master cylinder today and installed it, then bled the clutch/slave and adjusted the clutch. I WORKS! it no longer ingages at the floor! it does however slightly move when the clutch is in and I rev it up but not bad at all.

On a side note I took it for a drive and the steering wheel shakes and when I turn right I hear a grinding noise.... This is just depressing

06-11-2011	#19
GsXtUrBo98 Join Date: Nov 2007 Location: lino lakes Drives: 98 GSX, 04 is300 Posts: 1,856	Re: GsXtUrBo98's 2G project thread I got the new master cylinder today and installed it, then bled the clutch/slave and adjusted the clutch. I WORKS! it no longer ingages at the floor! it does however slightly move when the clutch is in and I rev it up but not bad at all. On a side note I took it for a drive and the steering wheel shakes and when I turn right I hear a grinding noise.... This is just depressing __________________ 98 GSX (built) 03 BBY EVO dd GSX 463awhp 363awtq on DB!