[mlomker]

Okay...I spent the last few hours going up one drill bit size at a time and the results were pretty predictable.

5/64ths: ~2psi
Port filter holder: ~2psi
Remove filter: ~1psi
3/32nds: ~2psi
7/64ths: ~2psi
1/8th: ~2psi

I'm now at the proper pressure at idle. I'm not going to worry about the filter since I have an inline under the hood. 1/8ths happens to be diameter of the top side of the tube so the solution was to just drill it out.

I'll have to see if the suction is still working but seeing how I went one bit a time, I think it will.