Thread: WTB: Machined 4g63 exhaust manifold
View Single Post
Old 05-15-2011   #5
blackrosenova400
 
blackrosenova400's Avatar
 
K Tire Racing Champion! Bowling Champion! Bowling Master Champion! Penguin Shot Champion! Ten Pin Bowling Champion! Yeti Strikes Back Champion! Ace Blackjack Champion! Billards Champion! Asteroid Miner Champion! Classic Frogger Champion! Donkey Kong Champion! Gauntlet 2 Champion! Luigis Mansion Champion! 1992 Champion! UrbanSlug Champion!
Join Date: Nov 2006
Location: Belle Plaine
Posts: 1,150
Re: WTB: Machined 4g63 exhaust manifold
I measured it, everything is flat except the very ends of runner 1 and 4. There is .006 inch gap on the very ends, which means its bowed very slightly.
__________________
20g Mafia
blackrosenova400 is offline   Reply With Quote