I started working on it today but since it's cold I didn't spend too much time on it, or put too much enthusiasm into it. Worked on it from about 10:30 till about 2:30
When I started on it the only thing off of it was the lower engine faring
Pulled off the gas tank, both seats, exhaust, air filter box and throttle bodies, loosened the rear plastics for access to wire connectors, radiator, oil cooler, disconnected all the necessary wires, and loosened the chain to get it off the drive sprocket. All that's left is to take out the engine bolts and pull the motor out of the frame. Then of course tear the motor apart and see what needs to be replaced.
