MitsuStyle - View Single Post

Kougar · 06-01-2004

Wow....GETTING PISSED. :headache:

Here's a quick re-cap....of hasn't worked

- Bled and Re-Bled then Re-bled again
- Adjusted the pedal
- Took shifter out, put it back in

also...

- Slave doesn't move back when pushed (not bad right?)
- Clutch pedal runs into the floor

So right now i'm leaning very heavily towards "Didn't install the damn TO bearing right." How the fuck did i screw that up? There are two clips that hold it to the release fork, they came off once while installing (put them back on) but i'm guessing they came off again. :fworld:

It's also possible i bent something when I let the tranny hang from the clutch area for about 30 second. Either way, I may just have the POS towed then have a professional do it right, since I'm obviosully incapable.

06-01-2004	#10
Kougar Join Date: Dec 2003 Location: Eagan Drives: 06 RSX Posts: 503	Wow....GETTING PISSED. :headache: Here's a quick re-cap....of hasn't worked - Bled and Re-Bled then Re-bled again - Adjusted the pedal - Took shifter out, put it back in also... - Slave doesn't move back when pushed (not bad right?) - Clutch pedal runs into the floor So right now i'm leaning very heavily towards "Didn't install the damn TO bearing right." How the fuck did i screw that up? There are two clips that hold it to the release fork, they came off once while installing (put them back on) but i'm guessing they came off again. :fworld: It's also possible i bent something when I let the tranny hang from the clutch area for about 30 second. Either way, I may just have the POS towed then have a professional do it right, since I'm obviosully incapable.