Wooooot baby it's fukn black Friday for scheides!!
Picked up the head from DB Performance and it looks HOT, big valves, nice basic port job, the dings are all fixed and the dual valvespring setup looks pimp. Shane helped me check the clearance on the tappets and half of them were perfect! We went to roll the intake cam over and it would not budge.
Seems like the cam was improperly machined from Kelford.
so, option one is to put *everything* back together with the stock cams and try fire it up this weekend, or wait on the cams and wait further on tappets (I suppose I should check clearances on these either way). Either way Shane is being awesome and has been an insane resourse through this process.
After that I made my way to MAP to pick up the shortblock and gaskets. All I can say is that I am seriously impressed. The everything was actually ready to go at 10:30am today but I wasn't able to make it there until after 5. Engine looks freaking hot, wait till you see the rods. This is a 'stage 1.5' shorty, stock sleeves with their big bad stage2 rods.
I have a *pile* of other parts but I just pulled the car into the garage and immediately bailed--night out with the wife to make up for the massive checks I had to write today. If anyone wants to help tomorrow, give me a call or just show up, I will be getting started around 10am (?) and working all day/night untill it's done or I give up. Beer and food provided to those who draw their own blood, bust a knuckle, or get oil in your hair
