MitsuStyle - View Single Post - Didn't bleed lifters

trunks11 · 08-13-2010

I"m not trying to blame anyone, just find the problem, fix it, and get the car to run. The 02 housing is caked in oil, and leak down test pointed at the rings not seating.

I was hoping it was electrical, that's why I took it in. Every component of the system has been replaced or tested with a known working unit. I've tried two sets of injectors, new plugs, swapped out cas, coil pack, power transistor, injector power pack (silver box on firewall), the ecu was checked when link was installed. I have an afpr base fuel is at 38psi. There is no cel at any time.

08-13-2010	#16
trunks11 Join Date: Jun 2007 Location: Annandale Drives: like an old lady 458/1000 Posts: 160	Re: Didn't bleed lifters - 90 cold compression new engine I"m not trying to blame anyone, just find the problem, fix it, and get the car to run. The 02 housing is caked in oil, and leak down test pointed at the rings not seating. I was hoping it was electrical, that's why I took it in. Every component of the system has been replaced or tested with a known working unit. I've tried two sets of injectors, new plugs, swapped out cas, coil pack, power transistor, injector power pack (silver box on firewall), the ecu was checked when link was installed. I have an afpr base fuel is at 38psi. There is no cel at any time.