MitsuStyle - View Single Post

Mon$tar · 07-25-2010

OK, so I have 2 built motors now and since the other one is a little less street friendly I suppose I offer up my other motor:

Engine: 9.5:1 Ross Racing pistons, Groden aluminum rods, Buschur Racing lightened and knife edge crank, Steel O-ring, Moroso Racing oil pan, Magnus girdle (uninstalled)

Head: Built/tested/ported by Speed Injected; +1mm over Ferrea SS valves, Crower Springs w/ Titanium retainers, sleeved, L19s, AEM Tru Gears (red), Valve cover with -12an fitting and catch can. Motor has breakin miles.

Head:

Sleeved head and valve train:

Block, ss o-ring:

Still fresh:

I can sell it as a Short block or a Long block but of course looking to sell it complete.

I'll start off at $3500obo and work from there.

07-25-2010	#1
Mon$tar New Member Join Date: Apr 2010 Location: Sacramento Drives: '90 Talon TSi AWD/ '91 Galant 1302/2000 Posts: 18	THE ULTIMATE street/strip motor FS/GI OK, so I have 2 built motors now and since the other one is a little less street friendly I suppose I offer up my other motor: Engine: 9.5:1 Ross Racing pistons, Groden aluminum rods, Buschur Racing lightened and knife edge crank, Steel O-ring, Moroso Racing oil pan, Magnus girdle (uninstalled) Head: Built/tested/ported by Speed Injected; +1mm over Ferrea SS valves, Crower Springs w/ Titanium retainers, sleeved, L19s, AEM Tru Gears (red), Valve cover with -12an fitting and catch can. Motor has breakin miles. Head: Sleeved head and valve train: Block, ss o-ring: Still fresh: I can sell it as a Short block or a Long block but of course looking to sell it complete. I'll start off at $3500obo and work from there.