Quote:
Originally Posted by sleepydsm
The nut that holds 5th gear on can work its way loose, and then worse case scenario fall off or something. I guess a symptom is popping out of fifth.
What route are you going with the tranny?
|
Just a stocker, I was hoping this transmission would last me through this year, so then when I garage it for the winter I could upgrade then, but since I'm getting the replacement checked out by Chad so I'll be okay for a while I think...I hope
Quote:
Originally Posted by goodhart
I guarantee that's what happened Ling Ling. Here is a pic of that same nut from my 1st tranny. Except in mine, the nut actually sheared right off with a piece of the shaft still in it.
|
I'm damn near positive you're right. The timing with 5th gear popping out and the case cracking it makes perfect sense. I suppose it could be a lot worse.
Quote:
Originally Posted by goodhart
Also, if you have 950cc injectors and a Walbro 255HP, you have plenty of injector and fuel pump. Here is a video of a buddy of mine's setup (95tsi on here) And he has quite a few more mods than you on an E316G and E-85. He is on 880cc injectors and made 347HP and 361TQ.
|
That's a nice car! My expectations are being raised the more I read about e85 with the e316g.
When the transmission is out I'll be be doing the fuel pump rewire and addressing some of the small stuff. There's still a hefty exhaust leak from between the manifold and turbo, so a gasket is definitely in store. Also, the VC gasket is starting to seep a little, and it seems pretty wet by the oil pan too. Overall it'll be a good time to get a lot things done.