Quote:
Originally Posted by Kracka
The fatter side goes towards the valve cover. Make sure the rubber lines are tightly clamped on. You could also check to see if maybe your valve cover gasket is leaking.
|
I am pretty sure I put them on them on right. The clamps is what I thought needed a little adjusting. I'll take a look at that tonight.
Quote:
Originally Posted by Ronnie S
No. The ecu will Not shut down one cylinder.
You will need a pick to remove the injector clips.
Reflashing will not fix your issue.
|
When you say a "pick", is there an actual tool that you use to unclip these? I messed with it for a little while but with no light except my cell phone, it was a lost cause.
I got school tonight, tomorrow, and Friday night but I'll probably stop in on Saturday if I can limp it over to you guys. Hopefully nothing else breaks on the way down there
