[blackrosenova400]

Im contemplating installing an Evo VIII ecu into my 1g. Im looking into any insite that anybody has on programming/using the ecu. Also any knowledge on using it under full Speed Density would be helpful. I dont think anyone hear know what sensors need to be swapped by I will figure that out myself since its been done.

Would like to know

1. What program is used for tuning

2. How how is it to set up injectors with it (I do have an aem Injector Driver)

3. How hard would it be to set it up full speed density with my Aem 5 bar
MAP Sensor

4. What would i change with the ecu to tell it Im running a 2.4 liter motor instead of a 2.0.

5. Is there any way to control boost with an electric solenoid with the Evo VIII ecu

+ Any other information you would consider useful with tuning ect..

I am running speed density already with a Maft Pro but I like the idea of not needing a piggy back for full speed density. Plus its far easier to change a tune with an Evo VIII ecu instead of programming an Eprom Chip.