MitsuStyle - View Single Post

**scheides** · 11-25-2009

Got alky dialed in today, car rips again! virtual dyno room puts me right back where I was, around 420whp on evoM comparator mode. I had to mess with the load scaling to get timing where it was, but seems pretty good now!

So, I have 2 pending issues:
-knock on spool-up, or tip-in. I'll try messing with the tip-in table, but I haven't logged a lean condition yet and timing seems ok, so not sure what the deal is.
-2000-2800rpm jitter. Still searching, hoping to log it and find a work-around.

Just wanna say thanks to everyone that helped me get this far, I am SO happy with the new speed density setup, it is absolutely amazing.

11-25-2009	#9
scheides flips McGee Cribbage Square Champion! Great Mahjong: Classic Champion! Mah Jongg Solitaire Champion! Mahjong Connect Champion! MuMu Champion! Join Date: May 2004 Location: Minneapolis, MN Drives: BeaterX Posts: 12,900	Re: Speed Density on Evo ECU Got alky dialed in today, car rips again! virtual dyno room puts me right back where I was, around 420whp on evoM comparator mode. I had to mess with the load scaling to get timing where it was, but seems pretty good now! So, I have 2 pending issues: -knock on spool-up, or tip-in. I'll try messing with the tip-in table, but I haven't logged a lean condition yet and timing seems ok, so not sure what the deal is. -2000-2800rpm jitter. Still searching, hoping to log it and find a work-around. Just wanna say thanks to everyone that helped me get this far, I am SO happy with the new speed density setup, it is absolutely amazing.